yuba blogroll

Boda Boda Monkey Bars

Have you been wondering how to convert Monkey bars into Boda Boda Compatible Monkey bars? Here are a couple quick easy steps explaining how to make Boda Boda Monkey bars from the Mundo monkey bars. Hope it helps!

16

 

What you will need:

  1. Monkey Bars
  2. 2 sets of bar tape
  3. Pipe Cutter or Bandsaw
  4. 9/16 diameter Aluminum(2-20″ sections and 2-15 inch sections)
  5. 6mm or 1/4″ drill bit

Outside Support Rods

  1. Cut to size

10

 


2

-Remove 335mm from the center of both inside support rods (this is the rod with a hole in the center)

3

-Discard the middle section

2. Join together using custom connection rods

-Cut two 510mm rod using 9/16” diameter structurally sound steel or aluminum4

-Insert connection rods into outside support rods5

-Mark hole location of support rods onto both side of inside rods7

-Remove connection rods from outside support rods

-Drill 6mm or Œ” holes at each marked location

8

 

Inside Support Rods

1. Cut to size12

-Remove 335mm from the center of both inside support rods (this is the rod with a hole in the center)

-Discard the middle section

2. Join together using custom connection rods

-Mark the distance from the end of the inside to the edge

 

11

-Add distance together and cut an inside support rod of that size

13

-Repeat for second side14

 

Assembly

  1. Assemble monkey bars using standard monkey bar instructions, thumb but ensure bolt passes through connecting rod holes to pin the assembly
  2. Wrap monkey bars with bike tape  to protect against sharp edges

15

Thank you Sellwood Cycle of Portland for the great idea!

**Warning cutting bars does void warranty on monkey bars

Leave a Reply

Your email address will not be published. Required fields are marked *